Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste ÜberarbeitungBeide Seiten der Revision | ||
mikrotikvlanswitching [2021/08/17 08:29] – Fabian Horst | mikrotikvlanswitching [2021/08/17 08:37] – Fabian Horst | ||
---|---|---|---|
Zeile 4: | Zeile 4: | ||
https:// | https:// | ||
- | |||
From: https:// | From: https:// | ||
+ | |||
+ | ===== Einführung ===== | ||
+ | |||
+ | Many MikroTik devices come with a built-in switch chips that usually have an option to do VLAN switching on a hardware level, this means that you can achieve wire-speed performance using VLANs if a proper configuration method is used. The configuration method changes across different models, this guide will focus on setting up a basic trunk/ | ||
+ | |||
+ | Viele MikroTik Geräte kommen mit einem eingebauten Switch Chip der VLAN Switchting auf Hardware Ebene beherscht. Damit ist es möglich auch mit VLANs eine Geschwindigkeit wie auf dem Kabel direkt zu erreichen. Für die Konfiguration gibt es verschiedene Optionen. Diese Anleitung wird den Fokus auf die Trunk/ | ||
===== Other devices with built-in switch chip ===== | ===== Other devices with built-in switch chip ===== | ||
- | Warning: Not all devices with a switch chip are capable of VLAN switching on a hardware level, check the supported features for each switch chip, the compatibility table can be found Here. If a device has VLAN table support, then it is capable of VLAN switching using the built-in switch chip. You can check the device' | + | Warning: Not all devices with a switch chip are capable of VLAN switching on a hardware level, check the supported features for each switch chip, the compatibility table can be found Here. If a device has VLAN table support, then it is capable of VLAN switching using the built-in switch chip. You can check the device' |
+ | |||
+ | Achtung: Nicht alle Geräte mit einem Switch Chip unterstützten VLAN-Switching auf Hardware Ebene! Prüfe bei jedem Gerät die kompatibilität! Wenn ein Gerät eine VLAN-Switchin Tabelle hat ist es unterstützt. Du kannst die Funktion bei einem MikroTik mit folgendem Befehl prüfen: < | ||
+ | |||
+ | Hier ein Beispiel eines RB2011LS(mipsbe) | ||
+ | < | ||
+ | [admin@MikroTik] > /interface ethernet switch print | ||
+ | Flags: I - invalid | ||
+ | # | ||
+ | | ||
+ | | ||
+ | </ | ||
+ | ==== 2011,RB750 etc. Musterkonfiguration ==== | ||
< | < |