Seite anzeigenÄltere VersionenLinks hierherAlles aus-/einklappenNach oben Diese Seite ist nicht editierbar. Sie können den Quelltext sehen, jedoch nicht verändern. Kontaktieren Sie den Administrator, wenn Sie glauben, dass hier ein Fehler vorliegt. ====== TotoLink X5000R ====== * Links: https://openwrt.org/toh/totolink/x5000r * Links: https://www.cwnp.com/wp-content/uploads/pdf/802.11s_mesh_networking_v1.0.pdf * Links: https://openwrt.org/docs/guide-user/network/wifi/mesh/80211s * Links: https://wireless.wiki.kernel.org/en/developers/Documentation/ieee80211/802.11s Serial Interface: !TTL 3.3V! The communication settings are: 115200, 8N1 * Link: https://openwrt.org/toh/totolink/x5000r Factory Settings: http://192.168.0.1/ Passwort: admin Image File Flashen: Menü → Advanced -> Tools → Upgrade → Local Upgrade https://downloads.openwrt.org/releases/21.02.1/targets/ramips/mt7621/openwrt-21.02.1-ramips-mt7621-totolink_x5000r-squashfs-sysupgrade.bin Danach via: 192.168.1.1 einloggen Damit es läuft muss man den firmware blob tauschen der mit -ct muss weg und gegen den ohne ersetzt werden. Erst dann geht ac und mesh! Offensichtlich wird die zweite WLAN Karte nicht im normalen Release mit Kernel 5.4.x supportet in einer neueren Charge also mal Snapshot probiern Link: https://forum.openwrt.org/t/wireless-section-missing-on-x5000r-in-21-02/109729/5 Ich teste mal: https://downloads.openwrt.org/snapshots/targets/ramips/mt7621/openwrt-ramips-mt7621-totolink_x5000r-squashfs-sysupgrade.bin !Mit Snapshot gibt es keine GUI per Default! -> https://openwrt.org/docs/guide-user/luci/luci.essentials <code>opkg update</code> <code>opkg install luci</code> <code>opkg update</code> <code>opkg install luci-ssl</code> <code>/etc/init.d/uhttpd restart</code> <code>opkg update</code> <code>opkg list luci-i18n-\*</code> <code>opkg install luci-i18n-hungarian</code> Mit dem Image geht es schon wesentlich besser und die Interfaces sind da, Kernel ist dennoch 5.4 aber solange es geht? wpad ist nicht getauscht bisher. <code>opkg remove wpad-mini</code> War nicht drauf <code>opkg remove wpad-basic</code> War nicht drauf <code>opkg remove wpad-basic-openssl</code> War drauf <code>opkg install wpad-mesh-openssl</code> Muss wieder drauf Wifi Config: 2,4GHZ * Mode: AX * Channel: 6 * Width: 40 MHz * Mode: 802.11s * MeshID: MeshingFerry * Network: lan * WPA3-SAE: MeshingFerry 5GHZ * Mode: AX * Channel: 36 * Width: 160 MHz * Mode: 802.11s * MeshID: MeshingFerry5 * Network: lan * WPA3-SAE: MeshingFerry totolinkx5000r.txt Zuletzt geändert: 2021/11/25 18:15von Fabian Horst